BT30 ER 16 3.54" ER Collet Chuck Tool Holder
SKU
202-6524
Out of Stock
Shipping UPS Ground
Details
| Mfg SKU # | 202-6524 |
|---|---|
| Tool Holder Category | Collet Chuck |
| Brand | Shars Tool |
| shank size | BT30 |
| projection length | 3.54 |
| max rpm balanced to | G2.5 20000 |
| TIR (inch) | 0.0001 |
| drawbar thread size | M12x1.75 |
| Dual Contact Tool Holder | No |
| collet series | ER16 |
| collet chuck style | standard |
| collet nut thickness | 1.26"/32mm |
Spotlight
- Balanced to 20000 PRM at G2.5
- In a generic standard ER collet nut, an internal ring is off-centered so that an ER collet can be easily snapped into it and holds the ER collet in place. To minimize this off-centering, SHARS ER collet nut is optimized to distribute the flat sides' area to off-set the off-center.
- Made from alloy steel harden to 54-60 HRc
- Taper ground to AT3 or better accuracy standard for maximum contact with spindle.
- All critical surface are precision ground
- Concentricity is less than 0.0002" from taper to end mill pocket
- Each holder comes with a lab certificate on its taper accuracy and runout measurement
- Internal set screw is included and can be used as a stopping pin to prevent end mill or drill from sliding backwards while performing heavy cutting
- Coolant through capability by removing the internal set screw
