CAT50 1-1/2" x 2.16" Face Shell Mill Tool Holder

SKU 202-5385

CAT50 1-1/2" x 2.16" Face Shell Mill Tool Holder

Availability In stock

Shipping Ups Ground

SKU 202-5385
Mfg SKU # 202-5385
Tool Holder Category Face Mill Holder
Brand Shars Tool
shank size CAT50
projection length 2.16
TIR (inch) 0.0002
Nose Diameter 3.5
arbor diameter 1-1/2
Arbor Screw Diameter 1.874
Key Width for Face Mill Keyway 0.625
Full Details

Product Spotlight

  • H6 arbor tolerance to improve cutter chattering and overall cutting tool life
  • T.I.R. 0.0002" measured from CAT40 taper to face and arbor

  • Unique design feature in the flange to minimize the off-balance nature of CAT 40 taper specification.  On the side of flange where a half spherical hole is located, a "wall" is built around this hole to compensate the weight of the metal chips lost from forming this spherical hole.  This design allows the left side and right side of the holder to achieve 50-50 perfect weight distribution in its upright position, like the position inside a machine spindle.  Symmetrical design in evenly weight distribution will minimize centrifugal force in high speed spinning and thus maximize the holder's ability to hold the cutting tool concentric to spindle rotation.

  • Made from alloy steel harden to 54-60 HRc
  • Taper ground to AT3 or better accuracy standard for maximum contact with spindle.  All of SHARS CAT/BT/HSK tool holder use Stotz Air/Electronic Gaging for production and finish inspection. Stotz has been chosen by major aircraft companies as the best and most consistent gaging for tool holder shanks

  • All critical surface are precision ground
  • Each holder comes with a lab certificate on its taper accuracy and runout measurement