NMTB 30 ER16 ER Collet Chuck Tool Holder
SKU
202-1410
$81.90
In stock
Shipping UPS Ground
Details
| Mfg SKU # | 202-1410 |
|---|---|
| Tool Holder Category | Collet Chuck |
| Brand | Shars Tool |
| shank size | NMTB 30 |
| projection length | 2.76 |
| drawbar thread size | 1/2x13UNC |
| Dual Contact Tool Holder | No |
| collet series | ER16 |
| collet chuck style | standard |
| collet nut diameter | 28mm |
Spotlight
- Reduced nose diameter under the flange to allow compatibility to quick change system
- Taper ground to AT3 or better accuracy standard for maximum contact with spindle
- Runout is less than 0.0002" from taper to end mill pocket
- Made of alloy steel and hardened to HRc 58 and all critical surface is precision ground
- Internal set screw is included and can be used as a stopping pin to prevent end mill or drill from sliding backwards while performing heavy cutting
- Each holder comes with a lab certificate on its taper accuracy and runout measurement
- In a generic standard ER collet nut, an internal ring is off-centered so that an ER collet can be easily snapped into it and holds the ER collet in place. To minimize this off-centering, SHARS ER collet nut is optimized to distribute the flat sides' area to off-set the off-center
