NMTB 40 ER32 ER Collet Chuck Tool Holder

SKU 202-1401

NMTB 40 ER32 ER Collet Chuck Tool Holder

Availability Out of stock

Shipping Ups Ground

SKU 202-1401
Tool Holder Category Collet Chuck
shank size NMTB 40
projection length 2.76
drawbar thread size 5/8x11UNC
Dual Contact Tool Holder No
collet series ER32
collet chuck style standard
Full Details

Product Spotlight

  • Reduced nose diameter under the flange to allow compatibility to quick change system
  • Taper ground to AT3 or better accuracy standard for maximum contact with spindle

  • Runout is less than 0.0004" from taper to end mill pocket

  • Each holder comes with a lab certificate on its taper accuracy and runout measurement
  • In a generic standard ER collet nut, an internal ring is off-centered so that an ER collet can be easily snapped into it and holds the ER collet in place.  To minimize this off-centering, SHARS ER collet nut is optimized to distribute the flat sides' area to off-set the off-center